2uzfe Ecu Pinout May 2026

| Sensor/Actuator | Factory ECU Pin | Wire to Aftermarket | | :--- | :--- | :--- | | Crank Position (G1/G2) | E6-16 & E6-18 | Dedicated VR+ / VR- input | | Cam Position (G Signal) | E6-17 | Digital Input | | TPS Signal | E6-2 | Analog 0-5V Input | | ECT Sensor | E6-7 | Analog Temp Input | | IAT Sensor | E6-11 (On MAF) | Analog Temp Input | | Injector #1 | E5-10 | Injector Output 1 | | Ignition Coil #1 | E7-4 | Ignition Output 1 | | Fuel Pump | E7-6 | Aux Output (Ground) |

Pins E5-25 and E5-26 must have a clean ground. If these are loose, the ECU will reboot randomly while driving. Connector E6 (Sensors - The Critical Inputs) | Pin | Wire Color | Function | Diagnostic Test | | :--- | :--- | :--- | :--- | | E6-2 | Gray | Throttle Position Sensor (TPS) Signal | 0.5V (Idle) to 4.5V (WOT) | | E6-7 | Light Green | Engine Coolant Temp (ECT) | ~2.5V cold, ~0.3V hot | | E6-12 | Light Green/Red | Mass Air Flow (MAF) Signal | 1.0V idle to 4.0V redline | | E6-17 | Blue/Red | Camshaft Position (G Signal) | 5V square wave (scope req.) | | E6-18 | Black | Sensor Ground | Continuity to Chassis Ground | 2uzfe ecu pinout

If you are reading this, you are likely deep into a project involving Toyota’s legendary 4.7-liter V8, the 2UZ-FE. Whether you are troubleshooting a P0335 crankshaft position code, performing a standalone engine swap into a classic 4Runner, or trying to figure out why your Land Cruiser’s TCM isn’t talking to the ECM, you need the map to the brain. | Sensor/Actuator | Factory ECU Pin | Wire

The ECU pinout for the 2UZ-FE is not just a wiring diagram; it is the Rosetta Stone for making this indestructible engine run. Whether you are troubleshooting a P0335 crankshaft position

Never back-probe E6-18 with power. This is a dedicated sensor ground. If you ground it to chassis instead of the ECU, you will create a ground loop and introduce massive signal noise. Connector E7 (Outputs & Ignition) | Pin | Wire Color | Function | Notes | | :--- | :--- | :--- | :--- | | E7-1 | Black/Yellow | Starter Relay Control | Grounds to engage starter | | E7-4 | Gray/Red | Ignition Coil #1 (IGT1) | 5V trigger from ECU | | E7-5 | Gray | Ignition Coil #2 (IGT2) | 5V trigger | | E7-6 | Violet | Fuel Pump Relay Control | Grounds to turn pump ON | | E7-20 | Red/White | Check Engine Light (MIL) | Switched ground to cluster | Part 4: The 2005+ VVTi & Drive-by-Wire Pinout Changes If you have an engine from a 2005-2007 Tundra or 2006-2011 Land Cruiser, stop using the chart above. You need the "Electronic Throttle Control System" pinout.

Check the color codes above—Toyota was mercifully consistent with wire colors across decades. If the wire is Light Green with a Black stripe , it is almost always the Engine Coolant Temp sensor on every 2UZ made.